Electronics
 
Custom Speedo Driver Module- 50.00
This circuit was developed for the MS PNP's, but could also be of use for other installs. Its completely standalone, only needs 4 wires connected, and will drive your speedo on the cluster without having to go through the factory ECU first.  Only for use with 5 speed cars, as it would alter shift points on automatic trans cars. If your cars runs faster than 108 MPH in the 1/4, you could use this to delete the factory speed limiter.  For off-road use only.
Knock Out Module-  50.00
This circuit was developed for the MS PNP's, but could also be of use in other installs.  This unit will hook upto the factory Knock sensor on the engine block and monitor knock activity. If knock is detected, it will illuminate a LED on your dash to alert you optically instead of trying to rely on hearing it.  This is a must for people tuning Forced Induction cars! Simple 6 wire hookup.
Remote Ignition Coil Kit- 80.00
After around 8 PSI, the factory Quad 4 ignition system begins to fail under heavy load. This is because the Spark Plug Boots, or Plastic coil housing is leaking the spark due to elevated voltages required to spark in the much higher cylinder pressures.
To alleviate this problem, we offer a kit where we use DSM coils, and mount them outside of the motor, over on the shock tower. Then run regular spark plug wires back to the engine. This is a Plug-N-Play modification, and will require you to cut NO WIRES.
Fuel Pump Wiring Upgrade Kit- 35.00
When you demand optimal performance from your fuel pump, you MUST upgrade to larger power and ground wires for it. The fuel pump is normally supplied power through a puny 18awg wire. This wire will cause a voltage drop of over 3 volts before power makes it all the way to the back of the car. This new kit will provide you with everything you need to run 12awg wire and a better relay. This will get that voltage back up where it belongs so your pump can do its job at peak performance